Operation Manual
8 9
Connections
Terminals and Connectors
The 3010i, 3020i, 3050i and 3090Ci have standard two terminal crossovers.
Loudspeaker Cables
Specialist loudspeaker cables will offer a higher standard of reproduction than general purpose ‘bell’
or ‘zip’ wire. Use cable with generous amounts of copper for the front and centre channels. Thin cables
reduce the bass and restrict the dynamic range. Surround (rear) channels are less critical.
Speaker cable has a stripe or tracer along one core. By convention this is connected to the positive
terminals. The cables connecting the amplier to the front loudspeakers should ideally be the same
length. Never join cables - use complete lengths.
Preparing Cables
Split the cable to a depth of about 40 mm. Bare the wire to a
depth of 10mm and twist the ends to gather any stray wires.
Crop the cable leaving 7mm of bare wire exposed.
3010i, 3020i & 3050i & 3090Ci
ENGLISH (EN)
Before making any connections to your loudspeakers make sure that
all active units in your system are switched off at the mains. When
switching on your sound system or changing input sources, set the
main volume control at a low level. Turn up the level gradually.
30 mm
7 mm