binding

Q-BOT Micro Quadcopter Flight Control

Specification:

Remote control distance: more than 80 m

Drive motor current: 1500 mA

Low-voltage protection: 3.0V

Fail-Safe: after 2 seconds closing motor output

Outline dimension: 25 * 26 mm

Mounting hole size: 20 * 20 mm

The power cables (line) on this, is on a different place, but the motor config. is the same

PAGE 1
Q-BOT Micro Quadcopter Flight Control Specification: Remote control distance: more than 80 m Drive motor current: 1500 mA Low-voltage protection: 3.0V Fail-Safe: after 2 seconds closing motor output Outline dimension: 25 * 26 mm Mounting hole size: 20 * 20 mm The power cables (line) on this, is on a different place, but the motor config.
PAGE 2
Q-BOT Micro Quad copter Flight Control Features: A. The receiver At the back of the receiver it is two led’s, between the two led’s there is a little push button. Push this so the led on the left side is red. This was the only mode the Q-BOT would work on my TX (Spektrum DX6i) I don’t know if this is only on my radio BUT all channels are set to reverse… B. Bind The Q-BOT must be bound to the transmitter before it will operate for the first time.
PAGE 3
E. Fail-safe Motor will stop after 2 seconds when the flight control cannot receive the right signal. F. Flight control parameter adjustment The flight control can set up flight control sensitivity by the remote control sensitivity channel (GEAR). 50% as the dividing line, when sensitivity value is greater than 50%, it is the normal mode, the greater the sensitivity is, even more stable the aircraft is. So we advise beginner to adjust it to about 80 on the first flights.