User's Manual

A – Command Line Interface
Set Config Command
A-44 59056-02 A
0
InteropMode Propagates just the active zone set
throughout the fabric (True, compliant)
or the entire zoning database (False,
non-compliant). The default is True.
LegacyAddressFormat Available only when the InteropMode
parameter is False, this parameter
enables (True) or disables (False) the
use of legacy address formatting for
interoperating with non-FC-SW-2
switches. Refer to ”InteropMode” on
page A-44. The default is False.
Table A-10. Set Config Switch Parameters (Continued)
Parameter Description