User's Manual

2 – Using SANsurfer Switch Manager
Exiting SANsurfer Switch Manager
2-10 59056-02 A
0
 Click the Open Existing Fabric radio button to open the Add a New Fabric
dialog, which prompts you for a fabric name, IP address, account name, and
password. Refer to ”Adding a Fabric” on page 3-5.
 Click the Open Existing Fabric View File radio button to open the Open
View dialog which prompts you to specify a fabric view file that you saved
earlier. Refer to ”Opening a Fabric View File” on page 3-6.
 Click the Start Application Without Specifying a Fabric radio button to
open the SANsurfer Switch Manager window shown in Figure 2-2.
 Click the Open Configuration Wizard radio button to open the Config
Wizard to configure a switch, add a new switch, replace/restore a switch, or
recover or edit an IP configuration of an existing switch.
Figure 2-2. SANsurfer Switch Manager Window
2.3
Exiting SANsurfer Switch Manager
To exit a SANsurfer Switch Manager application session, open the File menu and
select Exit. If you have not yet defined an encryption key, the Save Default Fabric
View File dialog, shown in Figure 2-3, prompts you to save the current fabric view
as the default fabric view file. Enter an encryption key in the Default Fabric File
Encryption Key field. Re-enter the encryption key in the Re-enter Encryption Key
to Confirm field. Click the OK button to save the current set of fabrics to the
default fabric view file in the working directory.