Q Simplify QLA®4010/4010C User’s Guide 1-Gb iSCSI to PCI-X Host Bus Adapters IS0053302-00 B Page i
Q QLA4010/4010C User’s Guide 1-Gb iSCSI to PCI-X Host Bus Adapters Information furnished in this manual is believed to be accurate and reliable. However, QLogic Corporation assumes no responsibility for its use, nor for any infringements of patents or other rights of third parties which may result from its use. QLogic Corporation reserves the right to change product specifications at any time without notice.
Table of Contents Section 1 Introduction 1.1 1.2 1.3 1.4 1.4.1 1.4.2 1.4.3 How to Use this Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . General Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Technical Support. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Availability . . . .
Q Table of Contents Page viii PRELIMINARY PC0056105-00 C
Section 1 Introduction 1.1 How to Use this Guide The SANblade™ QLogic® host bus adapters (HBAs) supported in this document are described in the following paragraphs: ■ ■ QLA®4010 (single channel, full-height bracket, optical media) QLA®4010C (single channel, full-height bracket, copper media) The QLA4010 HBA is 32/64-bit, 33/66/133-MHz PCI-X to iSCSI over Gigabit Ethernet on optical media. The QLA4010C HBA is 32/64-bit, 33/66/133-MHz PCI-X to iSCSI over Gigabit Ethernet on twisted-pair copper media.
Q 1 – Introduction Features 1.3 Features ■ Compliance with PCI Local Bus Specification revision 2.2 and PCI-X Specification revision 1.0a ■ Supports the IETF iSCSI standard, with soft upgrades as the standard evolves ■ 32/64-bit, 33/66/133-MHz universal PCI-X ■ 1-Gbps, full-duplex Ethernet ■ Complete TCP/IP protocol off-load ■ iSCSI initiator and target modes ■ RJ45 Gigabit Ethernet connector (QLA4010C HBA) ■ Small form factor (LC) fiber optic connector (QLA4010 HBA) 1.
Q 1 – Introduction Technical Support 1.4.3 Contact Information IS0053302-00 B Address: QLogic Corporation 6321 Bury Drive Eden Prairie, Minnesota 55346 USA Telephone: +1 952-932-4040 Fax: +1 952-932-4018 Email: Technical Service Technical Training support@qlogic.com tech.training@qlogic.com HBA Support Web Site: support.qlogic.
1 – Introduction Technical Support Q Notes 1-4 IS0053302-00 B
Section 2 QLA4010/4010C 2.1 Installation in the Computer NOTE: For a Solaris SPARC operating system, the driver must be installed before installation of the HBA. See the associated readme.txt file for detailed instructions on how to install the driver. Before you install the QLA4010/4010C HBA in your computer, you need the following: ■ A screwdriver (usually a Phillips #1) ■ An optical mutimode cable with an LC-style duplex connector for the QLA4010 HBA.
Q 2 – QLA4010/4010C Installation in the Computer NOTE: ■ Some motherboards have two kinds of PCI bus slots: master and slave. The QLA4010/4010C HBA must be in a PCI bus master slot. (Some motherboards have PCI bus master slots that are shared with onboard devices. QLA4010/4010C HBAs do not work in shared slots.) ■ PCI connectors vary among system HBA manufacturers.
Q 2 – QLA4010/4010C Label 2.2 Specifications Tables 2-1 and 2-2 define the QLA4010/4010C HBA specifications. Table 2-1. QLA4010/4010C HBA Operating Environment Environment Minimum Maximum 0°C/32°F 55°C/131°F –20°C/–4°F 70°C/158°F Relative humidity (noncondensing) 10% 90% Storage humidity (noncondensing) 5% 95% Operating temperature Storage temperature Table 2-2. QLA4010/4010C HBA Specifications Type Specifications Universal PCI specifications PCI Local Bus Specification, revision 2.
Q 2 – QLA4010/4010C Agency Certification 2.4 Agency Certification The following sections contain a summary of EMC/EMI test specifications performed on QLA4010/QLA4010C (IS0410401/IS0510401) to comply with radiated emission, radiated immunity and product safety standards. 2.4.1 QLA4010 2.4.
Q 2 – QLA4010/4010C Agency Certification 2.4.3 Product Safety Requirements ■ UL, cUL ❑ ❑ ❑ ■ UL60950 CSA C22.2 No.60950 Third Edition 2000 Class I laser product per DHHS 21CFR J 73/23/EEC Low Voltage Directive ❑ TUV: ❑ ❑ EV60950-1:2001 EN60825-1:1994+A11+A2 2.4.4 QLA4010C 2.4.
Q 2 – QLA4010/4010C Agency Certification ■ VCCI, Class B ■ CNS 13438, Class B ■ AS/NZS 3548, Class B 2.4.6 Product Safety Requirements ■ UL, cUL ❑ ❑ ■ UL60950 Third Edition 2000 CSA C22.2 No.