QUICK START GUIDE [ Quick Start Guide ] STACKABLE CHASSIS SWITCH INSTALLATION QLogic 9000 Series z
Purchasers of OEM products should consult with their OEM for support. Please feel free to contact your QLogic approved reseller or QLogic Technical Support at any phase of integration for assistance. QLogic Technical Support can be reached by the following methods: Web http://support.qlogic.com E-mail support@qlogic.com The QLogic knowledge data base contains troubleshooting information for the QLogic adapters. Access the data base from the QLogic Support Web page, http://support.qlogic.com.
Quick Start Guide Installation Instructions Congratulations on your purchase of the QLogic® 9000 Series Stackable Chassis Switch. This guide describes the steps to install and activate your new switch using a Windows® workstation. For advanced options and instructions (including Solaris®, Linux®, and Mac OS X® installations), refer to the QLogic 9000 Series Stackable Chassis Switch Installation Guide at www.qlogic.com. NOTE: Do not apply power to the switch until instructed in Step 5. Step 1.
Step 4. Install Transceivers An SFP transceiver is required for each switch port that will be connected to a device. ❑ To install an SFP transceiver, insert the transceiver into the switch port and gently press until it snaps in place. The transceiver will fit only one way. If the transceiver does not install under gentle pressure, flip it over and try again. Step 5. Apply Power to the Switch The maximum current requirements are 10 amps at 100 VAC or 4.2 amps at 240 VAC.
Step 7. Connect the Workstation to the Switch ❑ Connect the CPU0 blade Ethernet port directly to the workstation using an Ethernet cable, or indirectly through a switch or hub. The Ethernet port automatically discovers straight and cross-over cables. You must have a live Ethernet connection when the workstation powers up. NOTE: The Maintenance Panel Ethernet ports on the front of the switch are disabled and should not be used for the initial installation.
Step 10. Run the Configuration Wizard ❑ Double-click the Enterprise Fabric Suite 2007 shortcut, or select Enterprise Fabric Suite 2007 from Start menu, depending on how you installed it. ❑ The Configuration Wizard tool auto-detects and configures the switch based on selected options and recommended settings. Follow the instructions to set network parameters and the password. The default user name is admin; the default password is password.
© 2009 QLogic Corporation. QLogic, the QLogic logo, and Enterprise Fabric Suite are trademarks or registered trademarks of QLogic Corporation. Solaris and Java are registered trademark of Sun Microsystems. Linux is a registered trademark of Linus Torvalds. Mac OS is a registered trademark of Apple Inc. Windows and Internet Explorer are registered trademarks of Microsoft Corporation. NetScape Navigator is a registered trademark of NetScape Communications Corporation.
Corporate Headquarters QLogic Corporation 26650 Aliso Viejo Parkway Aliso Viejo, CA 92656 949.389.6000 www.qlogic.com *50688-05 50688-05 A Europe Headquarters QLogic (UK) LTD.