user manual

2
Installation Instructions
This Quick Start Guide describes how to install and configure your new QLogic SANbox 6140 Router by following these
steps:
❑ Step 1. Verify the package contents.
❑ Step 2. Pre-installation checklist
❑ Step 3. Mount the router.
❑ Step 4. Install the SFPs.
❑ Step 5. Apply power to the SANbox 6140 router.
❑ Step 6. Install the SANsurfer
®
Router Manager.
❑ Step 7. Configure SANbox 6140 management port IP address.
❑ Step 8. Run the configuration wizard.
❑ Step 9. Presenting LUNs to iSCSI initiators
Step 1. Verify the Package Contents
The QLogic SANbox6140 Router is shipped with the following items:
❑ SANbox 6140 Router (1)
❑ Small Form Factor Pluggable (SFP) transceivers (2)
❑ AC power cord (1), CD (1), and Serial adapter (1)
Optional equipment:
❑ Shelf for Rack Mount
Step 2. Pre-installation Checklist
During the initial configuration process, the user will be requested to input the following parameters. Please write down
the IP addresses in the space provided.
Parameter Value
Symbolic Name of this SANbox 6140
IP address (if not using DHCP) for the management
port in the SANbox 6140
IP address, subnet mask & gateway (if applicable)
for the GE 1(iSCSI port 1)
IP address of the iSNS server for iSCSI Port 1
(if iSNS will be enabled)
IP address, subnet mask & gateway (if applicable)
for the GE 2 (iSCSI port 2)
IP address of the iSNS server for iSCSI port 2
(if iSNS will be enabled)