User's Manual

Error! Use the Home tab to apply
标题
1 to the text that you want to
appear here. Error! Use the Home
tab to apply
标题
1 to the text that
you want to appear here.
SuperDVR & H.264 Series Cards
User Manual
36
HDD space shortage alarm.
1. Video Loss
Users can select alarm output for this option. For example, users select
alarm_out1 and alarm_out3 for video loss. Then video loss of any channel will
trigger alarm_out1, alarm_out3 to show a red light in the Alarm output status
panel (refer to Figure3-6 for reference to this panel).
2. Disk Alarm
When HDD available space is less than the set value (see Figure4-9), it will
trigger alarm.
3. Sensor
Sensor 1: If users have mounted sensors, when the sensors have been
activated, it will trigger the selected output alarms.
Sensor 2 - Sensor 16: Two QSPD4116 cards have a maximum of 16 sensors.
4. Motion
Motion 1: Users can set the output of motion detection alarm by different
alarms and remote alarm.
Motion 2 - Motion 16: 32CH card has maximum 16 motion alarms.
NOTICE: You should choose our additional alarm device board while
using two QSPD4116 cards for alarm I/O.
4.5.4 Auto Mail Function
Users can select the above-mentioned alarms to be output by Auto Mail.
NOTICE: Before you setup this function, make sure the DVR is set to
Motion Recording.
Click ‘Auto Mail’ icon on the left top side of alarm configuration page to enter
the following area to make Auto Mail setup, refer to Figure4-12.