User's Manual

ManualsBrandsQ-See ManualsMedical AlarmsQ-See Q-See - Digital Peripheral Solutions Medical Alarms QSDR16RTC/B

Q-See is a registered trademark of Digital Peripheral Solutions, Inc.

Digital Peripheral Solutions, Inc.

8015 East Crystal Drive,

Anaheim, CA 92807

www.Q-See.com

Quick Start Guide

Set Up

Connect

Enjoy

Quick Start Guide – Remote Internet Monitoring

H.264 DVR Model Numbers: QSD9004, QSD9004V, QSDR04RTC,

QSDR74RTS, QSDR174RTC,

QSDR008RTC and QSDR16RTC/B

Remote Internet Monitoring

Summary of content (5 pages)

PAGE 1
Quick Start Guide Quick Start Guide – Remote Internet Monitoring H.264 DVR Model Numbers: QSD9004, QSD9004V, QSDR04RTC, QSDR74RTS, QSDR174RTC, QSDR008RTC and QSDR16RTC/B 1 Set Up 2 Connect Remote Internet Monitoring Digital Peripheral Solutions, Inc. 8015 East Crystal Drive, Anaheim, CA 92807 www.Q-See.com Q-See is a registered trademark of Digital Peripheral Solutions, Inc.
PAGE 2
1 Set Up 2 A If you are only accessing the DVR from a computer attached to the same router: If you are accessing the DVR from a computer attached to the same router as the DVR, then you only need to setup the information in the NETWORK settings by using either the DHCP option, or assigning a static IP (See instructions below). Note: Knowing the public IP address is not necessary for this option, as you are just going from one location to another on the same network port forwarding.
PAGE 3
4 Option 4: DDNS: You can access the DVR through a static or dynamic IP address; however a dynamic address can change from time to time. How often it changes will depend on your Internet Service Provider. When the IP address changes, you can determine your new IP address by going to www.myipaddress.com from the computer attached to the same router as the DVR. You can avoid these steps by getting a static IP address from your Internet Service Provider so that your IP address does not change.
PAGE 4
B Accessing the DVR through Internet Explorer Browser (IE): Once the network settings on the DVR match the settings of your router, and you have forwarded the ports needed by the DVR (for remote access over the internet), you need to modify your browser controls. To connect to the DVR from a remote computer, you would then open an Internet Explorer browser window and enter the Internet IP of your router that you received by going to www.myipaddress.com.
PAGE 5
D NetViewer Interface: 3 Enjoy CONGRATULATIONS on your purchase! This Q-See product has undergone extensive quality control. If you have any issues during the setup process, please contact our support department before returning the product. We have your solution! 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 1) Need assistance setting up the remote monitoring feature with your Q-See DVR? Visit www.portforward.com/qsee Live, Replay, and Setup options PTZ Controls PTZ Setup Invoke PTZ settings.