User's Manual

To connect to the DVR from a remote computer, you would then open an Internet
Explorer browser window and enter the Internet IP of your router that you
received by going to www.myipaddress.com.
B Accessing the DVR through Internet Explorer Browser (IE):
Once the network settings on the DVR match the settings of your router, and you have
forwarded the ports needed by the DVR (for remote access over the internet), you need
to modify your browser controls.
Page 5
To Modify Internet Explorer controls:
Enable the “Pop Up Blocker” option by going to the Internet Explorer Tool Bar, and
selecting TOOLS (RED box, B1), select the POP UP BLOCKER from the drop down and
select TURN OFF POP-UP BLOCKER (BLUE arrows, B1).
You will also need to enable Active
X Controls by going to the Internet
Explorer tool bar, and selecting the
TOOLS option. Select INTERNET
OPTIONS from the drop down
(GREEN arrow, A1), prompting a new
display window to open (B2).
Go to “Security” (RED box, B2), and click on
CUSTOM LEVEL (GREEN box, B2). Click OK
(BLUE arrow, B2). This will open the security
settings (B3). On this page scroll down to the
ActiveX Controls and Plug Ins, and set all to
either PROMPT (BLUE arrows) or ENABLED
(RED arrows).
B2
B3
Page 6
If you get an error message “Program cannot load because the Publisher is
unknown” or the program is unsigned, then go to Internet Explorer > Tools >
Internet Options (B1), then click on the ADVANCED tab on the top right (B4). This
will open the window in (B5), scroll down to “Security”, and select on the options
to “Allow software to run or install even if the signature is invalid”, and “Allow
Active Content to Run Files on My Computer” (RED box, B5).
C Remote Viewing Window
When you connect you will see the remote viewing window shown below:
B4
B5
B1