Technical Manual

18 19
QC8116
Front Panel
ENTER
1
9
2
10
3
11
4
12
5
13
6
14
7
15
8 ACT POWER
STATUS
16
HD NVR 16 Channels QC8116
1
4
3
2
HD
FNSHIFT
/
0
/
8
/
6
/
9
/
7
/
5
ESCREC
1 2 6
7 8 10 11
3 4 5
9
Number Item Function
1
Channel
Status Lights
These lights will illuminate to indicate that a particular channel
is recording.
2 Status Lights
Net and HDD will illuminate if there are problems with the
network connection or hard drive, respectively. The power
light will illuminate when the NVR is powered up.
3 IR Sensor Infrared Receiver for Remote Control
4
Directional
Buttons
Navigate through menus.
Change selections in pull down menus (Up/Down buttons)
Toggle settings (Up/Down buttons)
5 Enter Button
Viewing Mode: Go To Menu
In Menu: Acts as mouse click
6 Power Button Puts NVR into Standby mode or wakes it up.
7
Video
Playback
Buttons
Play back video forwards or backwards. Pressing the same
button a second time will pause the video.
8
Playback
Speed
Slow or speed up playback - 1/4 speed to 4x speed.
9
Frame
Playback
Move forward or backwards frame-by-frame through video.
Works when video is paused.
10
Funtion
Buttons
Rec - Begins manual recording on all channels
Esc - Exit any menu or current operation
Shift - For use in Virtual Keyboard
Fn - Single Channel Viewing Mode: Opens Color Adjustment
Virtual Keyboard: Backspace function
11 USB Port
For use with flash drive when backing up or updating
firmware. Not for use with mouse.
If the user is logged out, pressing the Enter button will open the Login window. Pressing the
Function button will open the Virtual Keyboard which can be navigated using the directional
buttons. Click Enter to enter a keystroke. Press the Escape button to close the Virtual Key-
board and then press the Enter button to submit your password.
RS232
1 2 6
10 12 1411 13 1615
3 4 8 95 7
Rear Panel
Number Item Function
1 Power Switch
Turns NVR on or off. Use Shutdown menu function or front
panel power button before switching off.
2 Fan Cooling fan exhaust port. This should not be blocked
3 POE Block
Powers up to 16 directly-connected cameras and receives
video images.
4 Audio In BNC input for audio feed from microphone
5 VGA Video Out To connect to a VGA monitor (19” or larger)
6 Video Out BNC Connector to television
7 USB (x2) Use for USB mouse and external USB hard drive.
8 RS232 Reserved for use by manufacturer.
9 RS485 For controlling peripherals using the RS485 standard
10 Power input Attachment point for power cord
11 Network Ethernet cable connection to network
12 Audio Out BNC Connector for audio output
13
HDMI Video
Out
To connect to an HD display
14 eSATA Connection for external eSATA hard drive for backup
15 Alarm Input Connect up to 16 external alarm sensors to this block.
16 Alarm Out
Connect up to 4 external alarms using the Normally Open
(NO) or Closed (C) port