Technical Manual

74 75
PAN/TILT/ZOOM
Speed
Zoom
Focus
Iris
1
Channel
Page Switch
Set
PTZ Trace
SIT
1
Use the mouse to control the direction of
the camera’s movements by clicking on the
arrows.
Speed – From 1 to 8
and adjust zoom, focus and iris
Intelligent Positioning Key
If your protocol supports it, clicking on the
blue area at the center of the directional
controls will hide the control panel and allow
you to select an area to zoom in on with the
cursor. Right-clicking with the mouse will
return you to the control panel.
PAN/TILT/ZOOM
Speed
Zoom
Focus
Iris
1
Channel
Page Switch
Set
PTZ Trace
SIT
1
PICTURE 5-6
PICTURE 5-7
PICTURE 5-5
View 1
View 4
View 8
View 9
View 16
Pan/Tilt/Zoom
Auto Focus
Color Setting
Search
Record Status
Tour Setup
Remote Device
Alarm Output
Main Menu
STEP 3. Click the save button once you have entered the settings. If you are operating an
identical PTZ camera on another channel, you may use the Copy and Paste buttons
to apply those settings to the channel that camera is connected to. Be sure to check
that the camera’s address did not change as well. Each PTZ camera must be on a
different channel and have a different ID.
CONTROL
Right-click the mouse to bring up the
Shortcut Menu. Select Pan/Tilt/Zoom to
access the Pan/Tilt/Zoom control panel
(Picture 5-6)
SETTING PRESET/PATROL/PATTERN/SCAN
Clicking the Set button in the PTZ Control Panel (Picture 5-6) opens a new window in
addition to leaving the PTZ Control Panel active.
This window allows you to set up the PTZ’s Preset, Tour, Pattern and Border functions.
Preset
STEP 1. Start by using the eight direction arrows on the PTZ Control Panel (Picture
5-6) to position the camera where you want.
PICTURE 5-8
STEP 2. Click the Preset button in the
Function list and enter the number
you want to assign to this preset.
To create another preset point, change the
Preset Number and repeat steps 1 and 2.
Your camera supports up to 255 Preset
Points. When you have created the desired
preset points, you may use them to create a
tour.
PAN/TILT/ZOOM
Preset
Patrol No.
Set
0
1
Del Preset
Function
Preset
Tour
Pattern
Border
PAN/TILT/ZOOM
Preset
Patrol No.
Add Preset
0
1
Del Preset
Del Tour
Function
Preset
Tour
Pattern
Border
PICTURE 5-9
Tour
A tour is the sequence of points that your
camera will move to automatically before
returning to its starting point and repeating.
You can create up to 8 tours.
STEP 1. Click the Tour button in the
Function list and enter the number
of the preset you wish to add to it.
STEP 2. Click Add Preset to enter it
into the tour. You can have up to 80
presets in a single patrol.
STEP 3. Assign the tour a number
You can remove a preset point by clicking on the Del Preset button and an entire tour can be
deleted using the Del Tour button.
IMPORTANT! If your NVR is set to record when motion is detected, the
movement of your PTZ camera can create false alarms. You should adjust the
channel’s mode of recording as well as how it sends notifications to avoid this.