Technical Manual

12 13
1 2
QC814
Front Panel
QC824
Front Panel
Number Item Function
1 Status Lights
These show the status of the network connection, power and
hard drive respectively. The Network and Power lights will
normally be on. The Hard Drive light will normally be off.
2 USB Port
For use with flash drive when backing up or updating
firmware. Not for use with mouse.
3
POE Power
Input
48V power input for the Power Over Ethernet (POE) block.
4
NVR Power
Input
12V power input for the NVR itself
5
VGA Video
Out
To connect to a VGA monitor (21.5” or larger)
6
HDMI Video
Out
To connect to an HD display (21.5” or larger)
7 POE Block
Powers directly-connected cameras and receives video
images.
8 USB Connect the USB mouse to this port
9 Network
Ethernet cable connection to network. You cannot connect a
camera to this port.
Number Item Function
1 Status Lights
These show the status of the network connection, power and
hard drive respectively. The Network and Power lights will
normally be on. The Hard Drive light will normally be off.
2 USB Port
For use with flash drive when backing up or updating
firmware. Not for use with mouse.
3
POE Power
Input
48V power input for the Power Over Ethernet (POE) block.
4
NVR Power
Input
12V power input for the NVR itself
5 POE Block
Powers directly-connected cameras and receives video
images.
6 Network
Ethernet cable connection to network. You cannot connect a
camera to this port.
7
HDMI Video
Out
To connect to an HD display (21.5” or larger)
8
VGA Video
Out
To connect to a VGA monitor (21.5” or larger)
9 USB Connect the USB mouse to this port
Rear Panel Rear Panel
VGA
5 7 84 6 9
DC 12V
DC 48V
3
For full 1080P resolution video preview, you must use a 21.5 inch or larger monitor with
1920x1080 resolution.
Your NVR comes with two power supplies. The 48V is exclusively for use in powering the POE
block while the 12V 5A supply is for the NVR itself. The plugs and receptacles are different to
aid in connecting the proper power supply. Do not force or alter these connectors.
For full 1080P resolution video preview, you must use a 21.5 inch or larger monitor with
1920x1080 resolution.
Your NVR comes with two power supplies. The 48V is exclusively for use in powering the POE
block while the 12V 5A supply is for the NVR itself. The plugs and receptacles are different to
aid in connecting the proper power supply. Do not force or alter these connectors.
1 2
VGA
DC 12V
5 7 94 6 8
DC 48V
3