Quick Start Guide

ManualsBrandsQ-See ManualsSecurity CamerasWi-Fi Digital Wired Outdoor 1 Security Camera with Night Vision

1080p WI-FI OUTDOOR ENTRYCAM

QUICK START GUIDE

Rev. 10/22/18, GQCW2MPSL-E-V1.2

NOTE: Micro SD card slot and reset button are

located under the top cap

SPEAKER

LENS

RESET

BUTTON

PRECISE

MOTION

SENSOR

INDICATOR

LIGHT

SPOTLIGHT

MICROPHONE

MICRO SD

CARD SLOT

DISCLAIMER: Although Q-See has made every effort to ensure that the information in this guide

was correct at the time of printing, Q-See does not assume any liability to any party for any loss,

damage, or disruption caused by any errors, omissions, or typos that may occur.

WARRANTY & SUPPORT

Q-See is here to answer your questions and take your valued

suggestions. Please visit www.Q-See.com/support for 24/7 access to

our Support Portal or call 1-877-998-3440 Mon.-Fri. 6am-7pm PST.

Regulatory Information

FCC INFORMATION

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation.

Attention that changes or modification not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

Note: This product has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This product generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation.

If this product does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This equipment should be installed and operated with a minimum distance 20cm between the radiator and

your body.

SDOC Statement: www.Q-See.com/notices

Summary of content (2 pages)

PAGE 1
MICRO SD CARD SLOT RESET BUTTON Regulatory Information FCC INFORMATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
PAGE 2
WELCOME! Congratulations on your latest purchase and welcome to the Q-See family. This guide will help get your camera up and running. WHAT’S INCLUDED • (1) QCW2MPSL Wi-Fi Camera • (1) Power Adapter • (1) Power Cable • (1) Mounting Hardware • (1) Quick Start Guide IMPORTANT: Go through all of the steps to setup and test your device before mounting it. Visit www.Q-See.com/support to find the most recent guides and up-to-date support for your Q-See products.