User`s manual

QSD42908C8 User’s Manual
39
5.3 Unit Name and Device ID
Unit name
In the “Display” menu, shown as fig 5.8:
Fig 5.8 Display menu
There is an item called “Unit Name”. The default unit name is “Embedded Net
DVR”. Move “Active Frame” to unit name edit box, press【EDIT】key to enter into
edit status, you can modify the unit name. For instructions on how to input characters,
please refer to Chapter 3.4. Press【ENTER】key to finish modification. Select
“Confirm” button and press【ENTER】, you can save the new unit name and make it
effective. Press “Cancel” button or【ESC】key to abort modification.
Device ID:
When you use the remote control to operate the DVR, you must use the device ID
to select the DVR. The default device ID is “88”. If there is more than one DVR in
one place, please setup different device IDs for each DVR, otherwise the remote
control will control all the DVRs with the same device ID at the same time.
In “Display” menu, move “Active Frame” to the device ID edit box, in the edit
status, you can use numeric keys to input a new device ID. The device ID value is
between 01 and 255.
After you finish the modification, press the “Confirm” button to save and take
effect or press “Cancel” to abort modification.