Technical Manual

13
3 Protocol、Baud Rate、Address setup
3.1 Protocol and Baud Rate Setup
Please configure the following settings before begin controlling dome:
z Protocol
z Baud rate
z Address
Note: All the setup will only become activated after restart system!
Open the lower dome, the image is shown as below.
Protocol Baud rate Parity
1 2 3 4 5 6 7 8
Figure 1 Protocol baud rate and parity
1-4 is for protocol, 5 -6 for baud rate and 7-8 for parity. Please refer to Figure 2 to
Figure 4 for detail information.
1 2 3 4 Protocol
OFF
OFF
OFF OFF
DH－SD
ON OFF OFF OFF DAHUA
OFF ON OFF OFF PELCO-D
ON
ON
OFF OFF PELCO-P