Technical Manual

32
ADDR ：001-H
BAUD RATE ：9600
PARITY ：NONE
PROTOCOL ：PELCO-P
MODEL ：XX-SD
60XX
SOFTWARE ：1.20
FIRMWARE ：2.43
CONFIGURE DONE
X150.1/Y15.2 T：25
ZSYSTEM INFORMATION
CAMERA PARAMETERS
FUNCTION SETTING
ALARM SETTING
DEVICE CONTROL
EXIT
The diagram shown above illustrates the overall structure of the Setup Menu.
Note:
If you are using keyboard or matrix to control dome, please ensure the control
information setup (such as address, baud rate parity and protocol) are the same
with that of the dome.
Please ensure all the cable connections are right.
6.2 System Information
Figure 17 System information
After installation, please apply dome speed to power. The system will go on a
self-diagnostics. The above image will pop up to show the system information.
z ADDR: dome address
z Baud rate: dome communication baud rate
z Parity: communication parity bit format
z Protocol: current communication protocol
z Model: dome type
z Software: software version
z Firmware :hardware version
z Configure done: self-diagnostics is OK
z X150.1/Y152.2:horizontal address is 150.1 degree, vertical address is 15.2
degree T:25:dome temperature is 25 ºC
Note: This screen is for reference only.
6.3 Main Menu
Figure 18 Main menu
6.3.1 For DH-SD