Technical Manual

38
Figure 27 Auto pattern
The dome supports maximum 5 patterns and for each pattern dwell time limit is
60 minutes.
Highlight PATTERN and click confirm button.
z PATTERN NO： Here is to set pattern number. The value ranges from 1 to 5.
You can click left/right key to configure.
z PROGRAM START: Here is to memorize pattern starting point. An icon
pops up in screen.
z PROGRAM STOP：Here is to set pattern stop point. After all the movement,
highlight PROGRAM STOP and then click confirm button. Now you have set
one pattern. The icon disappears.
z RUN：Here is to activate pattern. Input pattern number, highlight RUN and
click confirm button, system begins running pattern. An icon pops up in
screen.
z STOP: Here is to stop current pattern. Input pattern number, highlight STOP
and click confirm button. System begins current pattern.
Note: The dwell time between two orders should be less than one minute.
Otherwise system will set to default value as one minute.
After click PROGRAM STOP, do not click RUN button before icon disappears
completely.
Any manual operation will terminate current dome pattern.
6.4.3.5 Privacy mask (Window blank)
PATTERN NO :001
PROGRAM START
PROGRAM STOP
RUN
STOP
BACK
EXIT