Technical Manual

42
Figure 31 Device control
Highlight DEVICE CONTROL and click confirm button.
HEATER POWER：Here is to control heater. There are three settings: auto, on
and off. In auto mode system will turn heater on in -1 º.
z FAN POWER：Here is to control fan. There are three settings: auto, on and
off. In auto mode system will turn fan on when it is over 20 º.
z STABLE FUNG: Here is for you to set image stabilizer function. There are
two modes: open/close.
z PELCO SELECT: This function applies for PECO-P/D users only. Here is for
users (For PELCO-P/D users only) to set shortcut options. Please refer to
chapter eight.
z CYCLE CAMERA POWER：Here is to reboot camera. Highlight CYCLE
CAMERA POWER and click confirm button, the system will reboot camera.
Note: For security reasons, when it is considerably hot or cold (such as it is over
40 º or below -20 º), system will automatically turn heater (or fan) on (or off).
6.5 Dome abnormal Phenomenon Operation
6.5.1 Restore to Factory Default Setup
From menu to SYSTEM INFORMATION, highlight FACTORY DEFAULT and
click confirm button. Dome will reboot and all the setup back to factory default
setup.
6.5.2 PTZ Movement is not so Smoothly
From menu to SYSTEM INFORMATION, highlight RESTART and click confirm
button. This reboot will not modify all activated setup (such as preset, tour and
pattern)
6.5.3 Focus is Blur
From menu to DEVICE CONTROL, highlight CYCLE CAMERA POWER and
click confirm button. System goes on a power off operation and then resumes its
original status.