Technical Manual

58
You can click ID button to enter current device
connection interface.
Highlight connection type and then click ENTER to set
RS 485.
485 address is 1 and select dome protocol as Pelco-P or
Pelco-D or Pelco-P1 or Pelco-D1.
Please refer to 8.4 Operation for more information.
9.3.2 Menu Operation
Pelco-P/D/P1/D1 is different from DH-SD protocol. So please pay attention to the
following instructions.
The operations are as follows:
Click GOTO button to call preset, input preset 28 or 95 to enter dome menu.
Please use up/down to move cursor and left/right to adjust value. Click OPEN
button in keyboard to confirm. (“Open” here is just the same to enter.) Please
refer to the following sheet for more information. Detailed operation instruction
please see chapter 8.
keyboard
PELCO-P/D PELCO-P1/D1
Enter dome
menu
Input preset 28 or 95 Press “MENU”
Move
cursor up
↑ or joystick up ↑ or joystick up
Move
cursor down
↓ or joystick down ↓ or joystick down
ON/OFF
and modify
other setup
← /→ or joystick move left
and right.
← /→ or joystick move left
and right.
Go to sub
menu
OPEN OPEN
Exit sub
menu
Move the cursor to highlight
back and then click OPEN
Move the cursor to
highlight back and then
click OPEN
Exit dome
menu
Move the cursor to highlight
EXIT and then click OPEN
Move the cursor to
highlight EXIT and then
click OPEN
Note:
• When you input preset to enter dome menu, please click ESC on the
keyboard to exit preset menu. Now you can use ↑、 ↓、← 、→or
joystick to move cursor.
485 address：1
Parity：None
Protocol：PELCO-P/D/P1/D1
Stop bits:
Baud rate：9600
Data bits：8