Technical Manual

60
SYSTEM INFORMATION
CAMERA PARAMETERS
ZFUNCTION SETTING
ALARM SETTING
DEVICE CONTROL
EXIT
PRESET
ZAUTO SCAN
TOURING
PATTERN
PRIVACY MASKING
BACK
EXIT
AUTO SCAN NO ： 001
SET LEFT LIMIT
SET RIGHT LIMIT
DEFAULT SPEED ：011
RUN
STOP
BACK
EXIT
9.4.2 Via Dome Menu
Note: Please do not click tilted direction key after you enter menu. Other
wise system will move all long. You need to exit menu to stop movement
(highlight EXIT and click confirm button)
9.4.2.1 Scan setup
1. Scan setup
(1) In DVR PTZ control menu, call preset.28 or 95.
System pops up dome menu, and dome enters menu
scanning. Click page switch button, system enters PTZ
control page. Up/down/left/right keys become menu
direction keys, the icon near the IRIS becomes enter
button. Move the cursor down to highlight “FUNCTION
SETTING”, then click confirm (Icon
near the IRIS).
System now goes to function setup menu.
(2)In function setup menu, you can set preset, auto
scan, touring, pattern. Highlight AUTO SCAN and click
confirm button. The dome is ready for you to set pattern.
(3) Move cursor to highlight Auto Scan NO. and use
left/right keys in dome PTZ control interface to adjust
value. The value ranges from 001 to 005.
Move cursor to highlight “set left limit” and then
click confirm button (Icon
near IRIS.). System pops up
OK to alert you that you have set left limit.
Move the cursor to highlight EXIT and click confirm
button (Icon near IRIS). Now the up/down/left/right
keys become PTZ control key. You can move dome to
another location.
(4) Repeat procedure 3 again to set right limit.
Move cursor to highlight “default speed”, now you
can use left and right key to adjust scan speed.
Move cursor to highlight run or stop and click
confirm button (Icon near IRIS) to begin or stop
scanning.