- Digital Peripheral Solutions Security Camera User Manual

QSTC201/211 IP-CAMERA USER MANUAL

5.4 Alarm configuration

Alarm configuration includes seven submenus: motion detection, motion alarm,

motion schedule, sensor alarm, sensor schedule, other alarm and alarm out.

5.4.1 Motion detection

Enter into “Alarm configuration"--"Motion detection" refer to Figure 5-7:

2. Select the channel to set motion detection parameters at the "Channel

Number" pull down list.

3. Move the "Sensitivity" scroll bar to setup the motion detection sensitivity.

4. Select the "Add” option, press the "Ctrl" button and move mouse to select the

motion detection area; select the “Erase” option, move the mouse to clear all

motion detection areas.

5. Press the "Save" button to save the settings.

Fig 5-7 alarm configuration-- motion detection interface

5.4.2 Motion alarm

1. Enter into “Alarm configuration"-- "Motion alarm" refer to Figure 5-8:

2. Select "Enable alarm" check box, all functions under this interface will be

activated.

3. Select "Alarm output" in the "trigger alarm out” text box, it will trigger alarm if

the device connected to alarm is triggered.

4. Select "Trigger snap”, user should also select a matched channel; the alarm