- Digital Peripheral Solutions Security Camera User Manual

ManualsBrandsQ-See ManualsSecurity CameraQSZ515D

QSZ515D

QSZ515DQSZ515D

QSZ515D

User’s Manual

Rev 120110

Part 1 Performance Features

4.2”Vandalproof Pan/Tilt Dome Camera

1/3” SONY CCD + SONY DSP

540TVL

Super wide voltage board: 8-18V

High transparent vandal-proof dome cover

5-15mm F2.2 2.0MP auto focus lens

With RS485 remote control, With 128 preset points

360° Horizontal endless rotation, 90° vertical movement

A panoramic view

body rotates flexibly with less noise and

wider view shooting

Memory function at accidental power-off (Settings saved)

Technical Specifications:

Model

PDS-320FZA

Image Sensor

1/3"SONY CCD

Digital Signal

Processor

SONY DSP

Signal System

PAL / NTSC

Scanning System

2:1 Interlace

Scanning

Frequency(H)

NTSC:15.734KHZ , PAL:15.625KHZ

Sync. System

Internal

Horizontal

System

540TVL

Effective Pixels

(HxV)

PAL:795×596

NTSC:811×508

Shuttle Speed

PAL=1/50 ~1/100,000 sec NTSC=1/60 ~1/100,000

sec

Mini Illumination

0.01 Lux

S/N Ratio

> 48dB Auto Gain Off

Gamma

0.45

Summary of content (7 pages)

PAGE 1
Part 1 Performance Features 4.2”Vandalproof Pan/Tilt Dome Camera ◇ QSZ515D 1/3” SONY CCD + SONY DSP ◇ 540TVL ◇ Super wide voltage board: 8-18V ◇ Medium Speed Intelligent Dome PTZ High transparent vandal-proof dome cover ◇ 5-15mm F2.2 2.
PAGE 2
Lens Built-in Decoder 1.3 Megapixel 5-15mm F2.2 2.0MP auto focus lens 1. Full digital design, all data saved inside of the module with memory White Balance Auto BLC Open 2. All in one integrated design, high reliability Video Output 1.0V P-P,75Ω BNC 3. 128 preset positions can be saved AGC Auto 4. 1-80 preset positions support auto cruise function, while 1 cruise route Power Voltage Super Wide Voltage (8V~18V) Input Current DC12V+/_20% 50/60Hz, 1.
PAGE 3
. 5. Large square of monotonous object, like a wall; The speed dome can be set in two fixed locations and scan back 6. The object is too dark or vague; h at the set speed. Set #126 for linear scanning. Set #xxx 7. The targeted picture is too small 3.
PAGE 4
Problem Possible reason Solution No movement and1.Check ima the connection of 1.Check the power ge at power-on C power input the soc connection, make sure 2.Turn off power and check ket is t well connected 2.Make sure the power outlet is he transformer working Power-on shows 1. DIP switch setting is incorrect 1. Refer to setup mage, 2.RS485 interface is not connec ons, re-set the DIP switches. but the controlle ted or is not r doesnot work connected 2.
PAGE 5
Baud Rate：2400, 4800, 9600, 19200Bit/S SynchronizedAddress Byte Code 00H Command Form：（） 03H 00H Preset Point Confirmation # Code Byte 1 b Byte 2 Byte 3 Byte 4 Byte 5 Byte 6 Synchronized Address Byt Command Cod Code Command Code Data Code Data e e 1 2 Byte 7 Code Confirmation Cod 1 Byte 1 Byte 2 Byte 3 Byte 4 Byte 5 Byte 6 SynchronizedAddress Byte Code 00H 07H 00H Preset Byte 7 Point Confirmation # e Code 1. All data in the Protocol as REX; Preset Point # Range：00 - FFH 2.
PAGE 6
Technical Parameter: Product features Model PDS-320FZA 1. Mini exquisite design with stable Image Sensor 1/3"SONY CCD performance 4.2” DOME cover Digital Singnal Processor SONY DSP Signal System PAL / 1.3 mega pixel lens NTSC 5-15mm F2.2 2.0MP auto focus lens Scanning System 2:1 Interlace Auto Focus; with the function of preset posit Scanning Frequency(H) NTSC:15.734KHZ , PAL:15.625KHZ ions in lens Sync.
PAGE 7
PELCO“P”Protocol PELCO“D”Protocol Baud Rate: 1200b/2400b/4800b/9600b