User`s manual

User’s manual of remote client software
Fig 2.5.18
Server configuration information:
Server name: not more than 32 characters, 16chinese at most.
Device ID: the biggest NO is 255 if the firmware is 1.5 or above. And if the firmware is 1.4
the biggest NO is 100.
Cycle record: if you want to overwrite after the HDD is full, just select “YES”, if you want to
stop record after the HDD is full, just select “NO”.
The channel number, HDD number, alarm input number, alarm output number, server type,
server serial are can’t be modified.
Network configuration information:
IP address, port and mask: server static IP, port and mask. The default port is 8000.
NIC type: here are some options such as 10M/100M Auto and so on.
DNS host IP: the DNS server IP should be inputted while the server use private domain.
Multicast IP: when you use the multicast, you should input a D-class IP. Between 224.0.0.0
to 239.255.255.255.
Gateway: if client software need go through the gateway to connect the server, you should
input a gateway.
NAS host IP and NAS directory: if use network store server, just input the NAS IP and the
directory.
Remote host IP and port: IP and port of the PC that used for receiving alarm information.
PPPOE parameters: if you want to use PPPOE dial up function, just select PPPOE and input
- 34 -