Owner manual

ms10
STARTUP TIME
ppm±10
70 °C ± 3°CFREQUENCY AGING (AFTER 1 YEAR)
ppm±1.570 °C ± 3°CFREQUENCY AGING (AFTER 30 DAYS)
%60/40DUTY CYCLE
7/nS2.5
80 MHZ - 100 MHZ
7/nS3.512 MHZ - 80 MHZ
7/nS7Below 12 MHZ
Output frequency:
RISE / FALL TIME
N/ASquarewaveOUTPUT WAVEFORM
6/Vdc
V
CC
x 0.9OUTPUT VOLTAGE - LOGIC "1"
6/VdcV
CC
x 0.1OUTPUT VOLTAGE - LOGIC "0"
7/-CMOSLOAD
mA5060 MHZ - 100 MHZ
mA3012 MHZ - 59.99 MHZ
mA12
Less than 12 MHZ
Output frequency:
INPUT CURRENT
Measured without load at 5.5 Vdc
Vdc5.554.5SUPPLY VOLTAGE
8/
kΩ
50CONTROL VOLTAGE INPUT IMPEDANCE
8/kHz10
DCMODULATION BANDWIDTH
%±10
LINEARITY
-PositiveTRANSFER FUNCTION
5/
PPM/VOL
T
12080TUNING SCALE FACTOR, AVERAGE
Vdc50CONTROL VOLTAGE (Vc) RANGE
4/PPM± 110
0 < Vc < 5
-55°C < T < +125°C
FREQUENCY DEVIATION
4/PPM± 25
Vc = 2.5 volts (center)
T = +25°C ± 2 °C
INITIAL FREQUENCY ACCURACY
1/
See Table IFREQUENCY/TEMPERATURE STABILITY
MHz100
3FREQUENCY RANGE AVAILABLE
UNITSMAX.NOM.MIN.
NOTESLIMITS
TEST CONDITIONS 2/,3/ELECTRICAL PARAMETER
TABLE Ill. ELECTRICAL PERFORMANCE CHARACTERISTICS
NOTES
1. The limit for frequency/temperature stability shall be referenced to the output frequency at 25 °C with Vc = any constant value
within the control voltage range.
2. Unless otherwise specified, the limits are over the full operating temperature range and under specified load conditions.
3. Unless otherwise specified, all measurements are in accordance with MIL-PRF-55310.
4. Referenced to nominal output frequency. Up to 30 days after shipment (does not include Aging). Center tuning voltage is
defined as Vc = 2.5 volts.
5. Slope of linear estimate (least squares) for 0 < Vc < 5V.
6. Voltage values are with respect to network ground terminal.
7. A standard CMOS load of 10 kOhm || 15 pF shall be used. See MIL-PRF-55310/26 for CMOS waveform measurement
definitions.
8. Tested at room temperature only.
Q-Tech Corporation
10150 W. Jefferson Blvd.
Culver City, CA. 90232
Specification number: QT725C rev A
Sheet 4 of 5