Operation Manual

Correct moving orientation Detection Angle

9m Max

120°

It can identify day and night automatically. And the working light can be chosen freely and make it work at

night and not work in the day time.

Illuminated time can be adjusted according to the customer’s desire.

Mini shell (57mm*44.5mm*28mm)

Sense LED: when it detect sensing signal, the LED flash.

Power source: 220-240V/AC

Power frequency: 50Hz

Rated load: 50W Max.

Detection range: 9m Max.

Time setting: Min: <5sec

Max:8min±1min(adjustable)

Detection angle:

120°

Light-control: <10~2000LUX (adjustable)

Working humidity: <93%RH

Working temperature: -25~+45

℃

Power consumption: <0.5W

Installation height: 0.7~2m

Black White

Summary

Characters

Specifications

Sensor information

RLX-1201

Infrared Sensor

Instruction

The product is a new saving-energy switch adopting the good sensitivity

detector, integrated circuit and SMT. It gathers automatic, convenient, safe,

saving-energy and practical functions. The wide detection field is made up of up

and down, left and right service field. It works by receiving human motion

infrared rays. When one enters the detection fields, it can start the load at once

and identify day and night automatically;It can be used with various types of

lamps and lanterns .

Unit:mm

IP:44

PAGE 1
RLX-1201 Infrared Sensor Instruction Unit:mm Summary The product is a new saving-energy switch adopting the good sensitivity detector, integrated circuit and SMT. It gathers automatic, convenient, safe, saving-energy and practical functions. The wide detection field is made up of up and down, left and right service field. It works by receiving human motion infrared rays.
PAGE 2
Connection-wire diagram Connect the power and the load wire with the sensor according to connection-wire diagram; Brown L ~input Blue Sensor N output Red Load Test After installation, before switching on power turn the time anti-clockwise to min; Switch on power, after 30sec the sensor enter stable working state; After the load turn off, sense it, the load should turn on, and under the condition that no continual sensing signal, the load should turn off within 5sec; When the light-control knob anti-cl
PAGE 3
Some problem and solved way    The load don’t work: a: Check the power and the load. b: If the load is good. c: Please check if the working light correspond to the ambient light. The sensitivity is poor: a: Please check if in front of the detection window there is hinder that effect to receive the signals. b: Please check if the ambient temperature is too high. c: Please check if the signals source is in the detection fields. d: If the moving orientation is right.