ENJOY Your QCA Paradise/Majestic Series Spa ML 900 Panel OWNER’S MANUAL This owner’s manual is for YOU! It will show you how to operate and maintain your very own spa. We think it is important for you to take a few moments and get acquainted with your new spa operation. Please keep this manual available for references. QCA Spas would like to congratulate you on your purchase and we sincerely hope you enjoy your QCA Spa. SERIAL NUMBER ______________ 18 DIGIT SPA NUMBER ______________ ParadiseSeries.
TABLE OF CONTENTS Cleaning the Filter Cartridge..........................................13 Draining the Water .........................................................12 Filter Maintenance ..........................................................13 Hydro-, Turbo-, Air-Max(tm) ..........................................10 Hyperthermia Description .................................................3 Initial Start Up ...................................................................5 Installation Instructions.
a. The water in a spa or hot tub should never exceed 40°C (104°F). Water temperatures between 38°C (100°F) and 40°C (104°F) are considered safe for a healthy adult. Lower water temperatures are recommended for extended use (exceeding 10-15 minutes) and for young children. UL INSTRUCTIONS The instructions you are about to read are required to be published in your manual by the Underwriters Laboratories.
WARNING - the use of alcohol, drugs, or medication can greatly increase the risk of fatal hyperthermia in hot tubs and spas. Electrical-General Prior to performing any service to the spa package turn OFF ALL primary electric power at the main circuit breaker or disconnect panel. Spa Location Opening the front cover of the electrical control box can make all field electrical connections.
Paradise/Majestic Series Initial Start-up Majestic and Paradise have the same buttons, only difference is logo When your spa is first powered up, it will automatically heat and maintain 100°F until you change the set temperature. In the event of a power failure or during a manual shutdown, the spa will revert to the last set temperature, mode, and filter cycle before the loss of power once power is restored. Self Diagnosis/Priming mode of spa takes six minutes.
the unit. If the light or LED unit is left on, it will automatically turn off after 4 hours. Standby Mode OPTIC Pressing “Warm” or “Cool” then “Jets 2” will turn off all spa functions temporarily. This is helpful when changing a filter. Button is not used for this model. Preset Filter Cycles Press any button to exit Standby mode. On all systems, the pump and the ozone generator will run during filtration.
similarly except t\with the temperature thresholds determined by the switch and without a 4-minute delay in turnoff. See you dealer for details. Locking the Panel Clean-up Cycle Press “Time” Jets 1” then the “Warm” with in 3 seconds. When locked the PL indicator light will light. All buttons are frozen except the “Time” button. To unlock panel, press “Time” “Jets 1” then “Cool.
persists, contact your dealer or service organization. Persistent low flow problems. (Occurs on the third occurrence of the “HTR FLOW LOW” message.) Heater is shut down, but other spa functions continue to run normally. Follow action required for “HTR FLOW LOW” message. HEATER MAY BE DRY – WILL RESET SHORTLY Inadequate water detected in heater. Check water level in spa. Refill if necessary. If the water level is okay, make sure the pumps have been primed. Press any button to reset.
Operating instructions for Ultra Wave Lounge™: To start your sequencer: Press on/off key to turn sequencer on. The system will then perform an indicator light test and open all valves. Pressing a second time will turn sequencer off. A built-in timer automatically turns sequencer off after 2 hours, unless manually deactivated first. To select and preview a sequence: Press sequences key to select one of the 7 preprogrammed massage sequences.
Control for Seats 1, 2, 3 & Directional Jet Wave-Max™ Seat Control Turbo Boost 5” Directional Aromatherapy Waterfall Wave-Max™ Seat (#5) & Ultra™ Wave Lounger (#4) These seats operate off Jets #2. The power can be diverted from Wave Max seat to Ultra Wave Lounge by rotating the diverter valve at the top of the Wave Max seat. To increase the action to these seats turn the blower on and rotate the Turbo Boost valve. Hydro-Max Seat™ (#2) & Seats 1 & 3 Turn on Jets #1.
Jets Spa Light All equipment Modules have a receptacle, located on the side of the Equipment Module. This receptacle is provided for the connection of the spa light. Directional Hurricane Jet-the graphite gray jet is operated by rotating the jet face counter-clockwise in full On position or clockwise for 95% shut-off. Your QCA Majestic™ Spa has a standard 12v light. The Spa light may be turned ON or OFF by pressing the Light button located on the spa side control.
SPAVAC™ Kit – Optional Your QCA SPAVAC™ can be used with garden hose pressure or provided vacuum hose. Your QCA Majestic Spa is equipped with a wall skimmer. For use with garden hose, the SPAVAC™ is equipped with a fine mesh screen bag which can be easily cleaned after use. For use with the vacuum hose, remove bag from the suction chamber, vac hose adaptor is then snapped into place. All debris will be removed through filter system.
dealer. When using this solution, follow instructions provided on label. 4. If the cartridge is coated with algae or bacteria, it should be soaked in a solution of one part chlorine and four parts water in a plastic container. As a safety precaution, rubber gloves should be worn while handling this solution. Brushing the solution into the fabric pleats may also help remove algae or bacteria. Rinse the cartridge thoroughly before placing it back into the filter housing.
products on the market that can be used for polishing. Made specifically for acrylic spas are cleaner/polish/sealer combinations, which contain reactive silicones instead of wax. If these are not available, any high quality silicone automotive polish will suffice. low-speed pump is automatically activated. This is a normal spa function; no corrective action is necessary. Freeze protection is enabled regardless of the spa's status.
To receive your FREE gift to help maintain your spa and to VALIDATE your spa warranty, return the PREPAID registration card below within the next thirty days. To immediately register your new spa; you may log onto our web site at qcaspas.com.
