ENJOY Your QCA Spa Q2000 Spa Pak OWNER’S MANUAL This owner’s manual is for YOU! It will show you how to operate and maintain your very own spa. We think it is important for you to take a few moments and get acquainted with your new spa operation. Please keep this manual available for references. QCA Spas would like to congratulate you on your purchase and we sincerely hope you enjoy your QCA Spa. SERIAL NUMBER __________________ 18 DIGIT SPA NUMBER ___________________ QCA Spa Q2000 10.
TABLE OF CONTENTS Air Control…………………………………………………………………….6 Cleaning the Filter Cartridge................................................................7 Diagnostic Messages ............................................................................6 Filter Maintenance ................................................................................7 Hyperthermia Description .....................................................................3 Initial Start Up................................................
1. READ AND INSTRUCTIONS. FOLLOW water temperatures are recommended for extended use (exceeding 10-15 minutes) and for young children. ALL 2a. DANGER - To reduce the risk of injury, do not permit children to use this product unless they are closely supervised. b. Since excessive water temperatures have a high potential for causing fetal damage during the early months of pregnancy, pregnant or possibly pregnant women should limit spa or hot tub water temperatures to 100°F (38°C). 2b.
Installation Instructions Spa Location The selection of a site for the installation of your spa is a very important decision and should be undertaken keeping several factors in mind. Electrical-General Prior to performing any service to the spa package, turn OFF ALL primary electric power at the main circuit breaker or disconnect panel. 1. Always check your local codes before installing your spa. A clear understanding of buildings, fences, gates, electrical and plumbing guidelines will be invaluable.
YOUR • QCA • SPA • EQUIPMENT Q2000 Control Initial Start Up Jets Control When first powered up, your spa will automatically heat and maintain 100° F or 38° C until you change the set temperature. Press the Jets pad once to turn on the pump and ozone generator (if installed). The pump and the ozone generator (if installed) will turn off after 15 minutes or will run until set temperature is reached.
Diagnostic Messages OH “Overheat” (Spa is deactivated) DO NOT ENTER THE WATER. If the spa water has reached 112° F, remove the spa cover to cool the water. At 110° F, the spa should reset itself. If the high-limit sensor detects 118° F, the spa will shut down. When the spa cools to 110° F, press any button to reset the spa. If the spa will not reset, then shut off power to the spa and call your dealer or service organization.
Daily Checklist Filter Maintenance 1. Test for proper chlorine or bromine level. Proper bromine level should be maintained at 2.0 - 4.0 ppm. As with any water filtering system, the filter cartridges may become clogged with particles or with calcification that will result in reduced water flow. In your QCA Spa, it is important to maintain a clean, unobstructed filtering system.
3. If the cartridge is coated with algae or bacteria or a hard, solid material, (which it may indicate a calcium build-up) on the fabric. This build-up can be removed by soaking the cartridge in proper cartridge cleaning solution available through your QCA dealer. When using this solution, follow instructions provided on label. Winterizing In very cold weather you may not want to venture outside to use your spa. In this case, you may move it to a heated area, or leave it as is until the weather warms.
WARRANTY REGISTRATION This warranty applies to spas manufactured by QCA DREAM SERIES™ Spas and sold to an original consumer purchaser at retail ("Purchaser") after June 1, 1998. To validate this warranty, the Purchaser must complete the enclosed warranty registration card and mail it to QCA/DREAM SERIES™ within 30 days of deliver of the spa. RETURN OF THE OWNER REGISTRATION CARD IS A CONDITION OF WARRANTY COVERAGE.
Troubleshooting Please Note: the spa owner may perform the following corrective actions. If the trouble cannot be corrected in the steps below, please refer to your QCA Dealer for service. (Improper servicing by an unauthorized serviceman or spa owner could result in damage that will not be covered by the warranty, or could cause serious injury.) SYMPTOMS CORRECTIVE ACTION Equipment Does Not Operate Check to see if the power cord is plugged in. Test the GFCI to see if it has "tripped".
To receive your FREE gift to help maintain your spa and to VALIDATE your spa warranty, return the PREPAID registration card below within the next THIRTY days. To immediately register your new spa; you may log onto our web site at qcaspas.