Instructions / Assembly

7. Electrical Installation Of Spa After Delivery
Important Safety notice for all models!
Proper grounding is extremely important.
QC 8000
VS 300
VS 501
VS 515
1. To gain access to the spa’s control box, remove the cabinet
panel on the front of the spa, under the spas topside control.
After removing the cabinet panel, remove the two control box
cover screws and cover.
2. Select the power wire inlet through the spa cabinet you
want to use. (Either drill a hole through the cabinet or run wire
in conduit through the base of the spa.) Then feed the power
cable through it to the left side of the control box.
3. Run power wire through the circular hole on the left side of
the control box.
4. Connect wires, color to color, into the terminal openings
and tighten securely. Connect ground wire to the ground
terminal and tighten securely.
5. Secure the control box door by installing its screws, then
re-install the cabinet panel under the topside control. Electrical
installation is now complete.
USE COPPER 240V WIRE MIN. 6AWG. 40A 60HZ
S
Y
S
T
E
M
B
O
X
Neutral Hot Hot Ground
W H T
B
L
K
R E D
G R N
CIRCUIT BOARD
GROUND
WHITE (NEUTRAL)
BLK (HOT)
RED (HOT)
GREEN (GROUND)
TB1
17