Q802MIG User Manual
Driver Installation When the system starts up the first time after the Q802MIG hardware is installed, the New Hardware Found Wizard will pop up and guide you through the installation of the driver. Select Install from a list of specific location (Advanced) and click the Next button.
Check the item Include the location in the search: and click the Browse button to locate the driver for Q802MIG. A window may pop up warning you that the software you are installing has not passed Windows Logo testing. Click the Continue Anyway button to continue the installation. The following window pops up to indicate the progress of the software installation.
When the process finishes, click the Finish button on the next screen to complete the driver installation. The Q802MIG is now ready for use.
Using Q802MIG Use Windows to configure the wireless network settings (Windows XP only) By default, Windows XP will provide automatic configuration for the Q802MIG. You can right-click the Network Connection icon on the System Tray and select View Available Wireless Networks to connect to the desired network. You can still use the Configuration Utility to view the status of Q802MIG.
Use Configuration Utility to configure the wireless network settings The Configuration Utility is installed automatically when you install the driver. You can find the Configuration Utility icon in the system tray. The Configuration Utility window pops up when you double-click the icon. In this window you can find the status of Q802MIG. You can click the Configuration tab to configure your wireless network settings.
The IBSS page allows you to choose the channel used by an Ad-Hoc (peer-to-peer) network.
The Domain page allows you to set the 802.11d Support and Countries/Domains if Q802MIG. Consult your network administrator to make your selections. In the About page you can find some useful information about the Q802MIG and its driver.
Appendix How to use the Configuration Utility in Windows XP In Windows XP, you can also use the Configuration Utility to configure the Q802MIG. Double-click the Network Connection icon, click the Properties button, select the Wireless Network tab, and un-check the item Use Windows to configure my wireless network settings. Then you can use the Configuration Utility to configure Q802MIG.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
