User Manual

30
Trouble shooting
PING
This section discusses possible solutions using ping command to find your problem if you can’t connect to the
network.
1. Check if you have a valid IP address
2. Test if your TCP/IP works. Under MS-DOS (command prompt), type “ping local-host”. If you didn’t
receive a reply, then you need to re-install your TCP/IP. Proceed to next step if you have received
replies.
3. Using the same procedure, try to ping your Wireless Adapter’s IP. If the Ping command fails, check the
following:
• Your WLAN is connected
• Check that your driver is correctly installed.