Specifications

- 4 -
WARNING
FOR YOUR OWN SAFETY READ INSTRUCTION MANUAL BEFORE OPERATING SAW.
• Wear eye protection.
• Use splash hood for every operation for which it can be used.
• Disconnect saw before servicing, when changing cutting wheels, and cleaning.
• Use tool only with smooth-edge cutting wheels free of openings and grooves.
• Replace damaged cutting wheel before operating.
• Do not fill water bath above water fill line.
ENGLISH
USE PROPER EXTENSION CORD. Make sure your extension cord is in good condition. When using an extension cord, be
sure to use a cord heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line
voltage, resulting in loss power and overheating. Table below shows the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.
MINIMUM GAUGE FOR CORD 18 AWG 16 AWG 16 AWG 14 AWG
TOTAL LENGTH OF CORD IN FEET 25 50 100 150
STATE-OF-THE-ART FEATURES
• Powerful 2-HP motor performs cutting jobs with ease.
• Automatic thermal overload protection protects saw
from power surges and motor overheating.
• Automatic power kill switch shuts off motor if power is
interrupted. Easy ON/OFF push button.
• Fiberglass-impregnated plastic water tray withstands
even the toughest punishment. Easy to remove and
install.
• Easily converts from a stand on wheels to a tabletop
configuration.
• Carrying handles for easy transporting. Optional saw
stand on wheels provides simple, one-man moving.
• Cutting table designed with free-rolling wheels to
assure accurate cutting.
• The adjustable rip guide allows both 90° and 45° cuts.
Universal wrench included.
• Rip cut up to 20" square tiles and diagonal cut up to
13" tiles.
• Versatile blade capacity from 6” to 10”.
ELECTRICAL / MOTOR SPECIFICATIONS
• Horsepower 2 H.P.
• Volts 115V
• Amps 16
• RPM (Variable) 3450
• Cycle 60
• Phase 1
• Class E
• Connect saw as close as possible to
power source.
• Belt A-26
EXTENSION CORDS: When using an extension cord,
ensure all cords are no smaller than #12 gauge, rated at
a 20-amp minimum, and equipped with 3-prong plugs.
Use of anything smaller may result in overheating or
burn out of the motor. It is recommended that an elec-
trician ensure that there is proper voltage at the saw
motor to run the saw efficiently and safely.
UNPACKING, ASSEMBLY & SETUP
CAUTION: FOLLOW ALL OF THE ASSEMBLY & INSTALLATION INSTRUCTIONS COMPLETELY BEFORE CONNECTING THE SAW TO
A POWER SOURCE OR TURNING THE MOTOR ON.
Carefully open the container and remove all saw components and packing materials. Ensure that you have checked each
item with the exploded view on Page 9 before discarding the container or packing materials. The contents of the con-
tainer are as follows:
• Wet Saw • 45° / 90° Rip Guide • Drain Plug • Water Pump
• Saw Frame • Universal Wrench • Front Extension Table • Side Extension Table
• Fiberglass-Impregnated • Owner’s Manual • Miter Block • Saw Blade
Plastic Water Tray
Carefully lift the saw by the saw frame handles and place it on a flat, level working area or on the optional stand on wheels.
The following pages illustrate step by step the installation of various components and operation of the saw. Read instruc-
tions completely before operating this saw!