Specifications

- 8 -
DOs & DON’Ts FOR DIAMOND BLADES
DOs
• Inspect blades daily for cracks or uneven wear. Discard cracked. chipped or bent blades.
• Always use manufacturer’s recommendation for matching the right blade with the right material being cut.
• Inspect the arbor shaft for uneven wear before mounting the blade.
• Always use blades with the correct arbor size on a compatible arbor shaft.
• Ensure the blade is mounted with the rotation arrow in the proper direction and is securely tightened with the wrench.
• Always wear the proper safety equipment at all times when operating the saw. Wear goggles and dust mask at all times
when operating saw.
• Periodically check the blade for cracks or bond fatigue.
• Always have a continuous flow of water on both sides of the blade before cutting any material.
DON’Ts
• Do not operate the saw without all safety guards in position.
• Do not operate the saw with blades larger or smaller than 10".
• Do not cut dry with blades marked “Use Wet”.
• Do not exceed maximum RPMs recommended by the blade manufacturer.
• Do not force the material into the blade. Let the blade cut at its own speed.
• Do not cut materiasl other than those recommended by the blade manufacturer.
ENGLISH
DESCRIPTION No.
Front Saw Stand 1-1
Side Saw Stand 1-2
Wheel / Brake Assembly
(w/(4) bolts, washers, nuts) 2
Stand Knobs (2) 3
Frame Assembly 4
Roller Guide Bar (w/(2) bolts, washers, nuts) 5
Water Tray Assembly 6
Drain Plug 7
Angle Bar on Water Tray
(w/(2) bolts, washers, nuts) 8
Water Tray Brackets for Lock (set of (2) w/screws) 9
Water Pump 10
Water Valve 11
Water Pump Tubing 12
Water Flow “T” 13-1
Water Flow “L” 13-2
“U”-shaped Roller Set 14
Cutting Table 15
Rubber Mat for Cutting Table 16
Ruler Guide (w/(4) bolts) 17-1
Ruler Guide Sticker 17-2
L-shaped Supporter (w/(2) bolts, washers) 18
Angle Bar Rollers Set 19
Rear Support Post
(w/bolt, washers, nuts, (1) hex) 20
Mounting Plate Adjustment
(w/nut & lock washer) 21
Motor Support Shaft (w/bolt & washer) 22
Mounting Plate 23
PARTS LIST – #60060 PROFESSIONAL WET SAW
Motor Adjustment Clip (w/bolt & washer) 24
Bearing Housing 25
Blade Shaft Lock Pin 26
Inner Flange 27
Outer Flange 28
Blade Lock Nut 29
Blade Guard 30
Blade Guard Bolt 31
Blade Guard Adjustment Knob 32
Belt Guard Bracket 33
Belt Guard 34
Blade Shaft Lock 35
Power Switch 36
Circuit Breaker 37-1
Waterproof Cover for Circuit Breaker 37-2
Power Switch Housing 38
Power Cord 39
Motor 40
Pulley 41-1
Belt 41-2
Single Socket 42
Splash Guard Flap 43
10” Continuous-Rim Diamond Blade 44
Rubber Mat for Front Extension Table 45
Front Extension Table 46
Rubber Mat for Side Extension Table 47
Side Extension Table 48
Miter Block 49
45°, 90° Rip Guide 50
Saw Stand w/Wheels 51
Universal Wrench 52