User manual

PBX-3011BT DISPLAY SYSTEM SETTINGS
PBX-3011BT
Select the mode of SYSTEM SETTINGS, 7 submenu from System setting will display.
9. System time: You can adjust the right time for the unit. After adjust the time, display will show
the time only when not in use.
Remark: When the unit is power off, the time you set will delete. You need to reset the time if
needed.
9
10. Back Light: Adjust the brightness of the display.
11. Language: The unit prior to English language. Enter the submenu of language to select other
language if needed.
12. Tools: The submenu of tools are Power Off, Keypad Tones, Alarm.
Power Off: Select the mode of power off the unit.
Keypad Tones: Select ON or OFF for the keypad tone.
Alarm: When the unit is ON, you can set the alarm after you adjust the correct time of the unit.
Alarm Cycle: You can select the unit' s alarm ring once, ring daily and ring multi- day.
Alarm Music: You can select the track from USB flash or SD to be the alarm music.
Alarm Volume: You can adjust the alarm volume, also the master volume.
13. Contrast: Adjust the contrast of the display.
14. Firmwave Version: The program version.
PBX-3011BT DISPLAY LINE MODE
When you select " AUX" from the main menu, the unit will turn to RCA Line mode.
PBX-3011BT MICROPHONE
1. Before powering on the microphone, be sure to set the Microphone Volume Knob to zero.
Once the microphone is powered on, slowly increase the microphone volume.
2. If you notice static or distortion in the microphone, check if XLR is fixed to the body properly
or echo volume is too high.
3. When not in use, turn off the power of the microphone.
-6-
Microphone
ON/OFF