User's Manual

Wall Mounting
Wall Mounting
You may choose to put the BASE UNIT of your cordless telephone on a wall.
1. With the back of the BASE UNIT facing up, connect the SHORT TELEPHONE LINE CORD to
the TELEPHONE LINE CONNECTION JACK.
2. Insert the free end of the SHORT TELEPHONE LINE CORD through the hole of the MOUNTING
BRACKET.
3. Insert the hooks of the MOUNTING BRACKET (following the arrow direction for the WALL
MOUNT) into the matching slots of the BASE UNIT (as shown below). Then slide the
MOUNTING BRACKET into place as indicated by the arrows. Plug the free end of the SHORT
TELEPHONE LINE CORD into the MODULAR WALL JACK.
4. Insert the tabs into the slot on one side of the base then press the tabs on the other side & snap
into the slot.
5. Align the upper keyhole on the MOUNTING BRACKET with the upper stud of the wall plate, so
that the opening end of the MOUNTING BRACKET matches the lower stud, then pull the BASE
UNIT down until it is securely seated
6. Place the HANDSET in the CHARGE CRADLE with its LCD Screen facing you. (See Figure 1)
Wall Mounting
FIGURE 1
IMPORTANT: A “beep” will be heard when the HANDSET is properly positioned in the BASE UNIT
CHARGE CRADLE and charging. Securely positioning the HANDSET in the BASE
UNIT will also prevent the HANDSET from falling
Base Unit