User's Manual

The device is provided along with four AC plugs complying with British standard, European standard,
American standard, Australian standard, as well as two bolts and two expansion plugs.
3.2 On-site preparations
Following items should be ready before installation.
necessary, for communication with A/C,
commu. distance < 1000m
not necessary, for communication with electric meter,
commu. distance < 600m
3. Installation
3.1 Components list
When unpacking, please check if all the following items are complete and intact.
3.3 On-site confirmation
Select a place with the consent of customer and also suitable for the adapter installation.
DC12V power line
H-NET commu. cable
485 commu. cable
Wireless router
Internet cable
preferred: TP-Link, Netgear
100Base-TX
necessary, make sure have access to internet. When
adapter connects to router in a wireless manner,
straight line distance < 15m, and supports only 2.4GHz
not necessary, applicable only when connecting to internet
with cable, commu. distance < 50m
•
Check the installation location and power
supply.
•
Check if all the embedded lines are ready.
•
Check if the air conditioner can run properly.
•
Check if WiFi covers when wireless connection is
adopted.
not necessary, applicable only when using DC12V
backup power interface
•
When power adapter is adopted, please confirm the
type of plug on-site, and select a proper AC plug.
•
Check if air conditioner is powered off.
3.4 Installation procedure
1) Drill as per the figure in the selected wall
(diameter: 6mm, pitch of holes: 44mm).
2) Position the expansion plugs into the holes
and insert the bolts with 3~5mm protruding
from the expansion plug.
3) Screw out the fixing bolts from the base of
adapter, and remove the bottom cover, then
perform wiring according to diagram.
Item
Wall
Pitch of holes
44mm
Bolt protruding
from the wall
3mm
1 1 1 1
preferred: 0.75mm
2
above, shielded twisted pair
Specification
preferred: 0.75mm
2
above, shielded twisted pair
Item
Adapter
Installation Manual
Power Adapter
Accessory Pouch
Figure
Quantity
preferred: 0.75mm
2
above, shielded twisted pair
Requirements
NOTE
4