Installation & Operation Guide

Page 08
13. Installing Batteries
a. Insert 4 AA high quality Alkaline batteries into the Battery Compartment in the
direction noted +/- on the Compartment. The Lock will beep 2 times, the keypad
will illuminate blue, and the Clevr button will green twice to signify that
it has received power (Figure 13a).
b. Slide the Battery Cover down into the track on the Interior Assembly to cover
the batteries (Figure 13b).
14. Testing Lock
With the Door Open
a. Test the Lock using the Interior Knob. The bolt should move smoothly.
b. Test the lock using the Keypad. To lock press and then press “ 123456 ”
to unlock.
INSTALLING INTERIOR ASSEMBLY (CONT.)
NOTE: Do not touch the Keypad until the blue light turns off.
Do not use rechargeable batteries or non-alkaline batteries.
INSTALLATION OVERVIEW
Cover
Touchscreen
Knob
Figur
Figur 3b
Key
Strike P late
3/4"(1 9mm)
Screws ( 4ea.)
Latch
Mounti ng Plate
Option al
3/4"(1 9mm)
Screw (1 ea.)
Interi or Assembly
Batter y Cover
5/16"( 8mm)
Screws ( 2ea.)
1"(25m m)
Screw (1 ea.)
1-1/8" (28mm)
Screws ( 2ea.)
Touch Keyp ad
Assemb ly