Installation & Operation Guide

Page 12

7 1 beep Bluetooh off

beep Bluetooh on

7 2

Warning sounds and LED red after 3 incorrect code attempts: Keypad shuts

down for 30 seconds.

To reset the lock to the original factory settings including the Programming Code

and all User Codes remove one battery for 10 seconds. Reinsert the battery and

wait for a long and short beep. Press 3 times within 3 seconds. The lock will beep

and the light indicator will turn green.

Beeps and LED

red for 5 seconds. Replace with good quality alkaline batteries.

Note: Removing batteries does not erase active Programming or User Codes.

NOTE: When battery is under low voltage, the lock will give the (Low Battery Warning: Beeps and

LED

red for 5 seconds). During this time your lock can still work. However once the voltage

is lower than 4.3V (called Super-Low Voltage), the operation of the locking and unlocking will not

work, user must replace batteries immediately.

Restore Factory Settings

Low Battery Warning

Consumer Friendly Message Guide

Bluetooth on and off

Unlock / Valid programming: 1 long beep and LED illuminates green

Lock: 2 short beeps and LED illuminates red

Invalid Programming: 2 short beeps and LED

red twice

Low Voltage: Beeps for 5 seconds

(7/9 times depends on operation is unlock/lock)

Super Low Voltage: 4 short beeps and LED

red four times

4 Incorrect code entry attempts: 2 short beeps and LED illuminates red each attempt

Power on: 1 long beep and 1 short beep and LED illuminates green

Chip Reset: 1 long beep and 1 short beep and LED illuminates green

(may occur several times or once in a while)

Lock Error: 3 long beeps LED

red three times

Repeat operation after Lock Error: 2 short beeps three times LED

red six times