Installation & Operation Guide

Page 04
3. INSTALLING THE DEADBOLT LATCH SET (need phillips head screwdriver)
a. Insert Deadbolt Latch Set into door edge hole with the word
“UP” and the arrow on the extension plate facing UP. Cross
shaped spindle connector will be at the bottom of the Deadbolt
Latch Set (Figure 3a).
b. Make sure the face plate sits with the door. Do not force
the latch into the mortise Chisel out excess material if
necessary for a
c. Using two 3/4” (19mm). screws provided, screw the latch into the
door with a hand held screwdriver. DO NOT OVER TIGHTEN.
4. IDENTIFYING YOUR DOOR HANDING
Stand outside the door.
a. If the hinges are on the left your door is Left Handed (Figure 4a).
b. If the hinges are on the right your door is Right Handed (Figure 4b).
NOTE: Deadbolt Latch must be Retracted when installing
NOTE: You are standing outside the door
INSTALLING DEADBOLT LATCH SET
OUT SWING DOOR
Figure 4a Figure 4b
Left Handed Door
Hinges are on the left side
Right Handed Door
Hinges are on the right side
Figure 3a
Deadbolt Latch Extended Deadbolt Latch Retracted