WIRELESS A/V TRANSCEIVER GM2400 User's Manual
If you have any questions related to this product, please E-mail to our company to : gadmei@gadmei.com, or visit our company's website at www.gadmei.com GADMEI-GM2400 User's Manual-V1.
4. FAQ and Troubleshooting Indicator does not light and there is no image 1. Make sure there is power supply of the transceiver. 2. Change receiver's transmitting channel (refer to operation instruction/ Channel switch). 3. Adjust transceiver's placement (refer to hardware and installation instruction). Infrared Control Feedback malfunction 1. Make sure that the connection and installation of the transmitter is correct.(refer to hardware and installation instruction). 2.
3.4 Infrared Remote Feedback GM2400 wireless AV transceiver doesn't need specified remote, but it has infrared remote feedback function. When emitting source came from set-top box (STB), DVD, video camera with remote function, remoter come with these equipments can be used directly on the receiver (TRV2400), while you don't have to operate the remote control of the AV equipments.
3.3 Channel Selection 1. Introduction Four transmission channels of 2.4GHz can be switched freely by pressing channel switch button. But only when the transceiver is in the same channel can video signals be transmitted normally. Panel indicator light for each channel selection mode goes as below: The first channel selection mode GM2400 wireless A/V transceiver consists of Transmitter (TXV2400) and receiver (TRV2400). It adopts advanced 2.
1.2 Application A/V to A/V wireless transmission, can be used when many televisions share one DVD/VCD or one digital set-top box and etc. Video conference system in large conference room, and multimedia teaching in classroom. Connect to pick-up head for monitoring;can be used in security systems. Building and industry monitoring system, long-distance custody of children and patient . Places where construction is difficult or cost is high. 3. Operation Instruction 3.
2. Hardware and Installation 2.4 Placement of receiver (TRV 2400) Please place receiver (TRV2400) beside the TV set, turn it on and connect AV cables according to relative colors (yellow,white and red). TRV2400 2.1 Transmitter (TXV2400) Buttons and Rear Panel Instructions TXV2400 TV set Video (yellow) Audio left (white) Channel switch Power switch source switch Audio right (red) 2.5 Placement of antenna Please pay attention to the placement of 433MHz antenna, ensuring there is no barriers around it.
2.3 Placement of Transmitter (TXV2400) For normal transmission,please place the transmitter(TXV2400) in the following two ways: Use infrared emitting equipment at the front of Transmitter: place the transmitter(TXV 2400) on top of AV equipments and keep a distance of 2-3cm between the edge of transmitter and the edge of AV equipments as the right picture.Point it to the infrared receiving window of AV equipments.
