User's Manual

Professional

FM Transceiver

Receiving

You can hear the transmitting party's calling when the channel you are operating is called and the

LED light turns green.

NOTE:

You may not receive the calling if you set a high squelch off level of the transceiver.

If current channel has been programmed with signaling, you can only hear the call from a same

signaling, other calls can not be heard.

Channels Selection

Under the standby conditions, turn channel selector knob to choose the desired channel, and

the transceiver will announce the adjusted channel. Turn clockwise to increase the channel,

anticlockwise to decrease the channel.

NOTE: The transceiver will emit a voice prompt when current channel is blank and the red light will flash.

BASIC OPERATIONS

Monitor

Pressing the programmed key of Monitor [PF1]/[PF2], the transceiver emits "DU" beep and then

comes into the monitor state. Under these conditions, transceiver will ignore CTCSS/DCS decode

and monitor signal of the other party as long as receiving the matched carrier wave. Press this key

again, transceiver emits "Du Du" beep and exits the monitor state.