User's Manual

Professional
FM Transceiver
3
BATTERY INFORMATION
How to Charge
Plug the AC adaptor into the AC outlet, and then plug the cable 1.
of the AC adaptor into the DC jack located on the back of the
Charger. The Backlight lights orange (1s) and then goes out,
lights green----waits to charge.
Plug the battery or transceiver into the charger. Make sure that 2.
the battery terminals are in contact with charging terminals
well. The Backlight turns into twinkling red-----Pre-charging
begins.
After pre-charging for about 5 minutes, the indicator will stop 3.
twinkling----charging begins.
It takes approximately 4.5 hours to fully charge the battery. When the lamp lights green, the 4.
charging is nished. Remove the battery or the transceiver is nished. Remove the battery or the
transceiver equipped with battery from socket.
NOTE: When charging a power-on transceiver equipped with battery, the indicating lamp will not
turn into green to show the fully charged status. Only when the transceiver is switched off, can the
lamp indicate normally. The transceiver consumes energy when it is power-on, and the charger can
not detect the voltage when the battery has been fully charged. So the charger will charge battery in
constant voltage and fail to indicate correctly whether the battery has been charged fully.