User's Manual

15
Shortcut Operations
In standby, hold
1.
key unti l th e
transceiver prompt DU, and channel
number ashes.
Turn selector knob to choose channel number for delete. (If the
2.
s
torage has data, the LCD will display the frequency, otherwise will
display"----------")
Hold Main band volume knob, until the transceiver emit DU DU
3.
prompt and LCD displays MEN-OUT, the channel delete completed.
CHANNEL DELETE
7
storage
has data , the LCD will display the frequency, otherwise will
display"----------")
Press
4.
key
, the LCD displays MEN-IN, channel copy completed.
6
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device does not cause any harmful
interference; and (2) this radio must accept any interference that may
cause undesired operations.
N
ote: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
WARNING
L
icensing Information
Use our radio in USA is subject to the rules & regulations of FCC. Changes or
modifications not expressly approved by our may void the user authority granted by
the FCC to operate this radio and should not be made. To comply with FCC
requirements, transmitter adjustments should be made only by or under the
supervision of a person certified as technically qualified to perform transmitter
maintenance and repairs in the private land mobile and fixed services as certified by
an organization representative of the user of those services. Replacement of any
transmitter component (crystal, semiconductor, etc) not authorized by the FCC
equipment authorization for this radio could violate FCC rules.
Note: Use of this radio outside the country where it was intended to be distributed is
subject to government regulations and may be prohibited.
Important: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this device. Your
radio is set up to transmit a regulated signal on an assigned frequency. It is against
the law to alter or adjust the settings inside the radio to exceed those limitations. Any
adjustments to your radio must be made by qualified technicians.
WA
RNING: MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE
S
ERVICE SIGNALS IS PROHIBITED UNDER FCC RULES AND FEDERAL LAW.
RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment shall be installed and operated with minimum distance 139.3cm
between the radiator & body.