User's Manual

16
General Setting
Once APO is activated, the transceiver will be automatically switched
off when the pre-set timer running out.
Press
1.
key to enter function menu.
Turn the Main band selector knob to
2.
choose No. 01 menu. the LCD displays "APO"
Press the Main band selector knob to enter function setup.
3.
Switch the Main band selector knob to
4.
choose wanted value.Available values:
0.5-12Hours, OFF
Press the Main band selector knob or
5.
key to store value and
back to function menu.
Press
key or hold selector knob for over 0.5 second to store
setup
and exit.
Only in frequency (VFO) mode, this function is valid. Turn selector knob
to select frequency or frequency scanning which is restricted by frequency
step size.
Press
1.
key to enter function menu.
Turn the Main band selector knob to
2.
choose No. 03 menu. the LCD displays "STEP"
Press the Main band selector knob to enter function setup.
3.
Switch the Main band selector knob to choose wanted value.
4.
Available Values: 2.5K, 5K, 6.25K, 10K,
12.5K, 15K, 20K, 25K, 30K,50K.
Press the Main band selector knob or
5.
key to store value and
back to function menu.
Press
key or hold selector knob for over 0.5 second to store
setup and exit.
When this function is on, the transceiver will automatically transmitting
with RX frequency ± offset frequency. The operation as following:
Press
1.
key to enter function menu.
APO (AUTOMATIC POWER OFF)
FREQUENCY CHANNEL STEP SETUP
AUTOMATIC OFFSET
Turn the Main band selector knob to choose No. 02 menu. the LCD
2.
displays "ARS"
Press the Main band selector knob to
3.
enter function setup
Switch the Main band selector knob to choose wanted value.
4.
ON: Auto Offset function is turned on.
OFF Auto Offset function is turned off.
Press the Main band selector knob or
5.
key to store value and back to function menu.
Press
key or hold selector knob for over 0.5 second to store
setup and exit.
When the Automatic offset is ON, the offset for 136-174Mhz is default on
0.6Mhz, and for 400-490 is default on 5Mhz.
7
NOTE
Basic operation steps for Function menu
1.
Press key to enter function menu.
2.
Turn the Main band selector knob to choose wanted function.
3.
Press the Main band selector knob to enter function setup.
4.
Switch the Main band selector knob to choose wanted value.
5.
Press the Main band selector knob to store value and back to
function menu. Press
key or hold selector knob for over 0.5
second to store setup and exit.