User's Manual

14
Frequency Adjusting
When the transceiver is in VFO frequency mode rotate the channel knob to adjust the frequency, or you
can input the frequency by the keypad.
Rotate the channel knob clockwise to increase the frequency, rotate it counterclockwise to decrease the
frequency. The frequency amount changed depends on the chosen frequency step. It will add or reduce
the frequency by the chosen step value.
VFO mode: if you want input frequency 151.820MHz, please press [1], [5], [1], [8], [2], [0] on the keypad.
BASIC OPERATIONS
Enter the desired frequency by increments.1.
Enter the desired frequency by keypad.2.
Receiving
When your transceiver receives a transmission, the LED light will light up (it will light green if the main band
is receiving and will light blue if the sub band is receiving) and the arrow icon will ash, and if the volume
is up high enough you will also hear the transmission.
NOTE: You may not receive the call if your transceiver is set at a high squelch level. If the current channel is
programmed with a mandatory decode (RX) tone (CTCSS, DCS, etc), the selected tone also must be present
for the call to be heard.