User's Manual

Table Of Contents

FUNCTION MENU SETUP

Note: User-defined CTCSS decode must be setup by programming software.

choose DCS positive or inverse code.

4. Rotate channel selector knob to choose desired CTCSS/DCS code.

CTCSS:62.5HZ~254.1HZ,51 groups in total, and 1 group user-dened code.

DCS: 000N-777I, 1024 groups in total. "N" stands for positive code, "I" stands

for inverse code.

5. Press or key to conrm and exit.

This function is for adjusting CTCSS/DCSencode/decode synchronous.(simultaneous changes Menu NO

01 and 02).

1. Press key, the top left corner of LCD displays " " icon, then press key to enter into function

menu.

2. Press

/ key to choose NO. 03 function item, it shows "RT-CDC" on LCD.

3. Press

key to choose CTCSS, DCS or OFF, when DCS signaling is selected, press key to

choose DCS positive or inverse code.

4. Rotate channel selector knob to choose desired CTCSS/DCSencode/decode.

CTCSS: 62.5HZ~254.1HZ, 51groups in total, and 1 group user-dened code.

DCS: 000N-777I, 1024 groups in total. "N" stands for positive code, "I" stands for inverse code.

5. Press

or key to conrm and exit.

CTCSS/DCS Encode/Decode Synchronous Setup