User Manual

SELECTING THE FREQUENCY BAND

This transceiver can be set working on 2 UHF band or 2 VHF band.

INPUT CHANNEL THROUGH MICROPHONE NUMBER KEY

In channel mode, you can switch to desired channel by press 3 of the

microphone numeric keys (001-750). For example input 001 get channel

1; input 030 is channel 30; input 512 is channel 512. If the input channel

is no frequency, the transceiver will emit a warning beep and return to last

channel.

1. Choose for Left band: press the left side

key to switch it to VFO

mode, press the left selector knob over 1 second then repeat above

operation will switch the left band.

2. Choose for right band: press the right side key to switch it to VFO

mode, press the right selector knob over 1 second then repeat above

operation will switch the right band.

Basic Operations

RECEIVING

If the transceiver has set at higher squelch level, it may fail to hear the

calling. If the

“BUSY”

and signal strength icon display in left band or

right band, but can not hear the calling, means the signal is with matching

carrier but dis-matching signaling.

In standby, both left band and right band are

able To receive. When they receive any signal,

the “BUSY” icon and signal strength icon will appear in the corresponding

area of the LCD. And you can hear the calling.

SQUELCH OFF/SQUELCH OFF MOMENTARY

Long press of key can be set up as Squelch Off or Squelch Off

Momentary to monitor the weak signal.

1. Squelch Off: Hold key until hear "Du" beep, the squelch is off,

repeat the above operation to resume squelch.

2. Squelch Off Momentary: Keep hold key to disable squelch,

release the key to resume squelch.

In standby, press the microphone

to cancel squelch, press it again

to turn on the squelch.

NOTE