User Manual

22
General Setting
Press
1.
key to enter function menu.
Turn the Main band selector knob to choose
2.
No.36 menu. The LCD displays "SHIFT".
Press the Main band selector knob to enter function setup.
3.
Switch the Main band selector knob to choose wanted value.
4.
Available Offset frequency for this transceiver is 0-100MHz.
Press the Main band selector knob or
5.
key to store value and
back to function menu. Press key or hold selector knob for over
0.5 second to store setup and exit.
OFFSET FREQUENCY SETUP
Before using Priority channel scan function.the edited channel shall be set
up as "P SCAN" or refer to the PRI instrunction in page 29 to add or delete
priority channel.
NOTE
7
Press the Main band selector knob to enter function setup.
3.
Switch the Main band selector knob to choose wanted value.
4.
MEN: Channel Scan, the transceiver will
scan all the channels after enter channel
scan.
MSN: Priority Channel Scan, the transceiver will only scan the priority
channel after enter channel scan.
Press the Main band selector knob or
5.
key to store value and
back to function menu. Press key or hold selector knob for over
0.5 second to store setup and exit.
Press
1.
key to enter function menu.
Turn the Main band selector knob to
2.
choose No.37 menu. The LCD displays
"DISPLAY".
DISPLAY MODE SETUP
Press
1.
key to enter function menu.
Turn the Main band selector knob
2.
to
choose No.38 menu. The LCD displays
"REPLOCK".
Press the Main band selector knob to enter function setup.
3.
Switch the Main band selector knob to choose wanted value.
4.
RLORP: Signaling busy lockout, when current
channel receives a matching carrier
but dis-matching CTCSS/DCS.
RLOBU: Channel busy lockout, when current channel receives a
matching carrier;
OFF: Busy channel lockout is disabled.
Press the Main band selector knob or
5.
key to store value and
back to function menu. Press
key or hold selector knob for over
0.5 second to store setup and exit.
BUSY CHANNEL LOCKOUT
Press the Main band selector knob to enter function setup.
3.
Switch the Main band selector knob to choose wanted value.
4.
FREQ: The radio displays channel number + frequency in channel
mode, if press
key,it will change to VFO mode.
CH:
Displays only channel number.
NAME: In channel mode, It displays the
channel number and channel name
if the current channel is set up with
a name. Otherwise, it display the
channel number and frequency.If
press
key, it will change to VFO
mode.
Press the Main band selector knob or
5.
key to store value and
back to function menu. Press key or hold selector knob for over
0.5 second to store setup and exit.