User's Manual

28
9
Reverse TX/RX
TX frequency turns to RX frequency & RX frequency changes to TX
frequency. The signaling will also be reversed if CTCSS/DCS signaling
exited in this channel.
In standby, press
1.
F
U
NC
, then press
MINI
, LCD displays "REV—ON".
Press [
2.
/ ] to select the desired value.
21Enable Frequency Reverse
2))Disable Frequency Reverse
3UHVVQXPEHUNH\VWRFRQ¿UPDQGH[LW
3.
In corresponding mode, press
F
U
NC
then press
MINI
key to enter into
scanning.
In scanning mode, press / to change scan direction.
Busy Channel Lockout
BCLO is to disable transmitting while RX signal is received. Once the
channel is busy and you press PTT, the radio will beep as warning and
get back to receiving.
In standby, press
1.
F
U
NC
, then press
MINI
to enter into Busy Channel
Lockout.
Press [
2.
/ ] to select the desired value.
%8 Enable BCLO, Carrier lockout, transmitting is inhibited when
current channel receives a matching carrier; press [PTT] to
emit error voice prompt.
5/ Enable BTLO, transmitting is inhibited when current channel
receives a matching carrier but dis-matching CTCSS/DCS.
Press [PTT] to emit error voice prompt It can transmit in any
receiving status.
2)) Busy channel lockout is disabled.
3UHVVQXPEHUNH\VWRFRQ¿UPDQGH[LW
3.
This function can be temporarily used in channel mode. Once the
radio is turned off or switched to another channel, the temporary
setting will be erased and back to initial settings.
Frequency/Channel scan
Scan Skip
:KHQ¿UVWELWRI([DE\WHLQIUHTXHQF\
displays ")", it indicates 5Tone function
enable.
This function can be temporarily used in Channel mode. Once the
radio is turned off or switched to another channel, the temporary
setting will be erased and back to initial settings.
This function can be temporarily used in Channel mode. Once the
radio is turned off or switched to another channel, the temporary
setting will be erased and back to initial settings.
Microphone Operation
In Channel mode, press
F
U
NC
then press
MINI
, decimal point displayed
between frequency's ten digit and unit digit, it means current channel is
scan skip. Repeat above operation to set scan or scan skip in current
channel.
decimal point displayed between frequency's ten digit and unit digit,
1.
it means current channel is scanned skip.
decimal point is not displayed between frequency's ten digit and
2.
unit digit, it means current channel is scanned.