User's Manual

25
8
Turn selector knob to select the desired LCD backlight brightness
3.
1-32 total 32 level backlight brightness.
Press
4.
TX/DCS
key to conrm and exit. Default:25.
Pilot Frequency
This function uses to start repeater. It needs a certain intensity Pilot
Frequency to start dormant repeater. As usual, no need to send pilot
frequency again once repeater started.
Press and hold
1.
F
U
NC
key for over 2s to enter general setting.
Press
2.
CA
LL
/
SCAN
key to choose No.25
menu, LCD displays "TB--1750".
Turn selector knob to select the desired
3.
pilot frequency.
1750HZ:Pilot frequency1750HZ
2100HZ:Pilot frequency 2100HZ
1000HZ:Pilot frequency 1000HZ
1450HZ:Pilot frequency 1450HZ
Press
4.
TX/
DC
S
key to conrm the selection
and exit. Default:1750HZ
Display Mode Setup
There are 3 different dispaly modes: Frequency+Channel mode, &
Channel mode&Channel+Name Tag mode.
Press and hold
1.
F
U
NC
key for over 2s to enter general setting menu.
Press
2.
CA
LL
/
SCAN
key to choose No.26 menu, LCD displays
"DSP—FR".
Turn selector knob to select the desired
3.
mode.
FR:Frequency+Channel mode(Amateur
transceiver mode).
CH:C ha n n el m o d e ( P r o fe s s io n a l
transceiver mode).
NM:Channel+Name Tag mode(Amateur
transceiver mode), if channel not
named, it displays Frequency+Channel
mode.
Press
4.
TX/DCS
key to conrm and exit. Default:FR.
PIN Setup
Enable this function, you have to insert a matching PIN to enter into
normal status when radio is turned on.(Pin setup by programme
software).
Press and hold
1.
F
U
NC
key for over 2s to enter general setting menu.
Press
2.
CA
LL
/
SCAN
key to choose No.27 menu, LCD displays
"CODE-OF".
Turn selector knob to enable/disable
3.
Pin setup.
ON: Turn on Pin setup
OFF:Turn off Pin setup
Press
4.
TX/DCS
key to conrm and exit.Default:OFF
This function will be auto-hidden if channel mode locked.(Refer to
programme software)
General Setting